How Much Oil Does A Dodge 3500 Diesel Take?

For the 2007-2019 6.7L Cummins diesel engine, 12 liters 5W-40 Ram Cummins diesel engine oil, oil filter, and hardware. RAVENOL low friction heavy duty diesel motor oil meets OEM approved Cummins CES 20081 oil specification. Fits the 6.7L Cummins Ram 3500 from 2007 to 2019.

Q: What’s the difference between 5W40 and 15W40?

In chilly conditions, the number to the left of the W relates to viscosity. In hot settings, the number to the right refers to the thickness. The oil is synthetically manufactured to obtain the qualities of the 5W standing. 15W40 oil can be synthetic or blended, though it’s more likely to have mineral grade components. When it comes to cold-starting the Cummins, 5W40 is the way to go. Are you experiencing a heat wave? Because of its excellent heat endurance, 15W40 is a good choice.

Q: How much oil does my Cummins take?

It’s always advisable to stick to the manufacturer’s instructions. The amount of oil required will vary depending on the vehicle’s make and model. Many vehicles have a 6.7 Cummins engine, and typical oil changes require 12 quarts. Top-ups are dependent on the state of your vehicle and the type of oil you’re using. Cummins engines are notorious for guzzling a lot of oil, especially older ones.

Q: How many miles does a 6.7 Cummins last?

Cummins was the first company to give 100,000-mile warranties, demonstrating its commitment to its customers. It’s said that you can get up to 350,000 miles out of the car, but it demands meticulous maintenance, including frequent oil and filter changes, careful driving, and pleasant road conditions. You may expect at least 100,000 miles, but after that, wear and tear, environment, and driving habits become more of a concern. If you look after your Cummins, it will look after you.

Q: How often should you change oil in a 6.7 Cummins?

Follow the manufacturer’s recommended maintenance schedule (particularly if you have a service contract). The frequency of oil changes is determined by the age of your vehicle, any existing damage, driving conditions, and the type of oil used. Consult this table to be sure, as it changes depending on the vehicle’s make and model. It’s advisable to change your oil every 15,000 miles, but if your warranty specifies otherwise, follow those guidelines.

Q: What weight oil should be used in a 6.7 Cummins engine?

Cummins recommends two Valvoline oils in particular for its engines. The 15W-40 oil is designed for temperatures above 0°F, whereas the 5W-40 is designed for extremely cold conditions.

Q: Are synthetic oils better for 6.7 Cummins engines?

That is a point of contention. Synthetics are preferred by some manufacturers and engine builders, whereas mixtures are preferred by others. What is general is that the lighter the weight of the oil, the less wear it will experience during cold starts.

Q: Is Valvoline Premium a good motor oil for 6.7 Cummins engines?

The Cummins factory expressly recommends Valvoline Premium Blue and Premium Blue Extreme motor oils. Cummins has thoroughly tested these oils and decided that they possess properties that make them excellent for diesel engines.

How much oil does a 5.9 Dodge diesel take?

Your engine’s lifeblood is motor oil, which lubricates and cools a complex system of fast-moving mechanical parts under high loads. Oil changes on a regular basis ensure that old, degraded engine oil is changed before it loses its chemical and mechanical qualities, increasing wear resistance. Cummins engines with 12v, 24v, and 24v common rail have different service intervals (see schedule below). If you fulfill one or more of the conditions, stick to the manufacturer’s recommended oil change interval and the alternative “heavy duty” plan.

L Cummins Engine Oil

The oil capacity of all 5.9L Cummins turbodiesels (6BT and ISB) is 12 quarts (with filter replacement) and the oil filter is the same. Engine oil should be changed according to the oil change interval chart below, using the viscosity stated in the corresponding chart. Oil aeration and low oil pressure can occur if the crankcase is overfilled or underfilled. After allowing the engine to cool for 15 minutes, check the oil level on the dipstick (oil in the top of the engine must drain back into the crankcase before checking oil fill level). In 5.9L diesel engines, neither Cummins nor Chrysler advocate using an additional oil additive. All engines should use a high-quality synthetic engine oil. Before installing the oil filter, fill it with around 1 quart of clean engine oil to avoid dry starts and guarantee that oil pressure increases fast after changing the oil.

L Cummins Oil Change Intervals

Towing, hauling, driving in stop-and-go traffic, many short trips, operating in hot weather, operating in extremely cold weather, and repeated periods of excessive idling are all examples of severe service conditions. Always follow the service interval that applies to your operating conditions. Unless your truck is utilized solely for commuting and your route includes just minor city travel, most vehicles will fall into the severe service category.

L Cummins Oil Change Parts List

Avoid cheap aftermarket filters; Fleetguard is Cummins’ service parts brand and is the recommended replacement oil filter for all Cummins turbodiesels. When the edges of the head begin to show indications of wear or the gasket develops a leak, replace the engine oil pan drain plug. To prevent particles/pieces from dislodging and dropping into the crankcase, replace the oil fill cap when it begins to show symptoms of wear.

L Ram Cummins Oil Change Procedure:

  • By placing the 3/8 drive into the drain plug and loosening it, the drain plug can be removed.
  • Use the oil filter pliers to loosen the oil filter, which may be accessed through the right side wheel well as indicated in the image above.
  • Remove the oil filter by spinning it (if you have it thread in the optional oil filter cap, without this oil will spill out of the filter and make a mess)
  • Pull the top out via the wheel well by tilting it toward the access panel (if you do not have a oil filter removal tool, oil will spill from filter)
  • Reinstall the oil fill lid after filling the engine with 11.5 quarts of new engine oil using the oil fill funnel.
  • Start the engine to allow the oil to circulate (while it’s running, check for any leaks or anomalies) and then turn it off.

To accurately track engine oil life, execute the engine oil life reset after the oil change is completed.

This article applies to Ram trucks with the 6.7L Cummins turbo diesel engine from the model years 2008, 2009, 2010, 2011, 2012, 2013, 2014, 2015, 2016, 2017, 2018, 2019, and 2020.

How much oil does a 2007 6.7 Cummins take?

12 pints of capacity.. (with filter) Start and run the engine to operating temperature after changing the oil, then stop and wait around 30 minutes for the oil in the upper portions of the engine to drain back to the pan.

What oil is recommended by Cummins?

The results were validated by millions of miles of real-world vehicle testing and intensive joint development activities. Valvoline Premium Blue 15W-40 was demonstrated to save upwards of $20,000 in annual oil maintenance costs and productivity savings for a 100-truck fleet* in a cost-benefit analysis comparing the use of conventional oil and synthetic mix CK-4 oils in the Cummins X15 engine.

“Everything matters when it comes to the performance and investment of your engine and motor oil—from the superior hardware components found in the Cummins X15 engine to the revolutionary formulation found in Valvoline Premium Blue,” says the company. It’s not a choice between the two.” Cummins R&D Director of Fuels, Lubricants, and Materials Roger England

“Together, we’ve integrated our products in a way that benefits our customer,” said Fran Lockwood, Valvoline’s Chief Technology Officer, “having a significant impact on their equipment’s health and, ultimately, their bottom line.” When you can extend oil life without sacrificing performance, you’ll save a lot of money in the long run.”

The 2017 Cummins X15 engine was precisely built to achieve outstanding overall efficiency, with a base engine fuel economy improvement of up to 3% over the EPA 2013 ISX15 engine and up to a 15-20% improvement over the EPA 2010 model. The Only OneTM recommended for all Cummins engines is Valvoline Premium BlueTM diesel engine oil, which provides long-lasting performance and protection.

“I am pleased we are able to offer them the dependability of our products to help them succeed with confidence over the long run,” said Kerk McKeon, Cummins Worldwide Chief Engineer. “I am pleased we are able to offer them the dependability of our products to help them succeed with confidence over the long run.”

*Assumptions include 125,000 miles per year, a $23/hour labor rate, and a $125/hour productivity loss rate.

How much oil does a 2016 Ram 3500 take?

In ambient temperatures below 0 F (-18 C), failure to use SAE 5W-40 synthetic engine oil could result in serious engine damage. 12 quarts of capacity (with filter) Start the engine after filling it up and let it idle for a few minutes.